Lada Niva / 2101-2107 Wiper Relay With Pause Regulation (Memory)

INSTALLATION AND OPERATING INSTRUCTIONS
 
1 Installing the wiper interrupter
ATTENTION!!! Installation of the breaker
when the battery is disconnected.
1.1. Disconnect the wiring harness from the stalk switch of the wiper by opening the 6-pin connector located behind the instrument panel or inside the steering column cover.
1.2. Connect the wiper blades of the wiper interlayer to the formed bundle of the wiring harness.
1.3 Using the connector, connect the free wire of the breaker to the wire connecting the stalk switch to the washer motor. This is one of the wires of the 2-pins of the stalk switch, the potential of which, when the washer is switched on, changes from +12 V to 0 V or vice versa (depending on the specific brand of the car).
1.4 Using the mounting hole of the interrupter, install it in a convenient place on the car. The wiper blade is ready for use.
 
 
2 Adjust the pause
2.1 Set the wiper mode switch to "Intermittent mode" - the standard wiper operation time will be set (approximately 5 seconds between brush strokes).
2.2 To change the pause, turn the switch to the "Off" position and, having held the required pause, move to the "Intermittent mode" position. A new pause value is set. The range of pause changes is from 0.5 to 45 seconds.
2.3 The pause can also be changed in another way: move the switch to the "Continuous" position and during the first stroke of the brushes - back to the "Intermittent mode" position.
The pause value will be equal to the time interval from the last stroke of the brushes to the moment of switching to the "Continuous mode" position.
The pause can be changed at any time by repeating paragraph 2.2 or 2.3.
 
3 Other modes
3.1 The stroke of the brushes with the water supply starts with a delay of 0.5 seconds (allows you to accumulate a sufficient amount of water on the windshield until the first stroke of the brushes).
3.2 After brushing, the brushes are made three strokes.