In this section you can buy the brake kit for Lada Niva 1600.
The device of a support
We go further. Mechanisms of the front axle - disk, consisting of supports with the main brake elements - shoes, and brake discs.
The support is a body, with the cylinders made in it for the pistons. They have this model - two, one for each shoe.
Pistons calipers look like a glass, which is placed in their cylinders, but on it they can move. To prevent leakage of liquid, the pistons are wearing sealing rings.
Pads are small metal plates, on which the lining of friction material is glued.
Brake disc - made of metal, for better adhesion to the surface of shoes, its lateral surfaces are well processed, so that there are no protrusions and shells on them.
The work of LADA brakes is performed as follows: the liquid moves into the cylinders of the caliper, where it begins to eject the pistons. Those come out of the cylinders, pressing the pads to the disk.
The device of the brake mechanism of a back axis
The rear axle brake system LADA has a different device. All its elements are hidden inside the brake drum:
The working brake cylinder LADA has such a device: there is a body, it is a cylinder, with two pistons placed in it. When the fluid pressure is applied, they exit the cylinder.
Pads - metal, made in the form of crescents, on the top edge of them are glued the friction. Pads installed on the hub form a ring.
In the lower part of the pads are installed in the seats placed under them, and in the upper part - into grooves made in the pistons. To spontaneously pads are not bred, they are tightened by springs. The parking brake mechanism is also located there.
On top of this, everything is dressed on the drum hub shaft. When braking, the liquid pushes the pistons, and since their pockets include pads, this movement of the pistons is accompanied by discordance of the pads. At the same time they are pressed against the drum and the rotation slows down.
In this section you can buy the brake disks for Lada Niva 1600.
We offer brake disks LADA: Alnas, ATS, Pilenga, ATE
Virtually all of the tuning of the VAZ is to increase the engine power. Increasing the engine power, the car starts to gain speed faster, the maximum speed increases. Do not forget about the effective reduction in the speed of the car, i.e., about the braking system.
Brakes on the design are disc-type drum. The effectiveness of disc brakes is much higher.
The VAZ brake discs also have a different design, the separation follows a diameter and additional modifications. Brake disks are: not ventilated, ventilated, with additional vent lines, and with perforations for better cooling of the disc. The disks are paired with the brake pads. When you press the brake pedal, the pads on the vase clamp the disc. On cars VAZ, the vacuum amplifier helps to achieve greater efficiency of braking.
Our company is a major distributor of VAZ brake discs from Alnas, the world's largest manufacturer. This company is the largest manufacturer of cast iron products and uses the most advanced technologies and the best equipment for processing on high-precision lines EMAG and HESSAPP (Germany). The company produces the highest quality products in the volume of up to 1,000,000 units per year. Alnas brake discs are supplied to the plants "VAZ", "GAZ", "UAZ", "ZAZ", "FORD", "Daewoo" for production cars since 2003. The technology of manufacturing brake discs Alnas is constantly improving, making the choice of buyers more and more obvious.
In this section you can buy the brake drums for Lada Niva 1600.
About brake drums LADA:
The rear brake system of VAZ cars consists of several elements: a brake cylinder, pads and a drum. The brake effect is realized when the liquid enters the cylinder through the tubes, which in turn presses the pads against the drum. They are of two types:
Aluminum with cast iron insert on the inside;
In connection with the fact that during the braking there is a strong heating of the parts, it was necessary to use materials with high resistance to wear. It is for this reason that the friction parts are made of cast iron steel. Brake drums are very durable, they can serve 100 thousand km or more without replacement. It all depends on the style of driving, aggressive acceleration and braking reduces the service life of both brake pads and drums. Therefore, when replacing consumables, you need to evaluate the state of the parts yourself.
In this section you can buy the brake pads for Lada Niva 1600.
Brake pads on the LADA - a very important element of the brake system of the car, directly affecting its effectiveness. The standard brake pads installed by the vehicle manufacturer are often not enough with an active driving style. Frequent acceleration and braking leads to the fact that the temperature of the brake pad is exceeded, and its efficiency drops sharply. The drop in the overall efficiency of the braking system leads to a deterioration in the handling of the car, causes a reduction in speed and greatly worsens the results, if it is a question of some kind of competition. But in the case of civilian driving, the consequences can be even worse - the low efficiency of the braking system affects exactly when you expect the least. When choosing brake pads LADA, always be guided by the expected driving style. For moderate urban driving, there is no point in putting pads with a high temperature threshold - they need to be warmed up so that their efficiency reaches an optimal level. For an aggressive driving style and amateur competitions, choose brake pads with a higher temperature range - their effectiveness with frequent braking will not fall, remaining at the desired level and providing you with an excellent result.
In this section you can buy the brake cylinders for Lada Niva 1600.
The rear brake cylinder is a metal device, on each side of which there are two pistons. It is thanks to his work that the brake pads are pressed against the drum.
The brake cylinder is very reliable and walks for a long time. But there are cases when it is required to replace it. One of the reasons may be product marriage. Since it is metal, the case can be cracked, which will cause a leakage of liquid. At the bottom of the pistons there are rubber cuffs that can be damaged during operation. They can get dirt and moisture, which will result in the failure of the pistons. Also, one more leakage point can be a fitting for bleeding the brakes.
If you notice that the level of the brake fluid in the tank is lower than the previous one, then it is worthwhile to inspect the elements of the system. The failure of the rear brake cylinders can be caused by the presence of streaks on it. Or, if the drum is removed, depress the brake pedal, and if only one shoe moves or no movement occurs, then a replacement must be made.
Vacuum brake boosters
In this section you can buy the vacuum brake boosters for Lada Niva 1600.
In our store there are vacuum amplifiers TRW, Torgmash
To reduce the pressure on the brake pedal, the vacuum brake booster VAZ is used. A standard vacuum amplifier is not able to provide the necessary effort to stop tuning a car with a large capacity.
The larger the diameter of the vacuum amplifier, the lesser the driver needs to stop the car. The standard LADA vacuum amplifier can also undergo tuning in order to reduce the brake pedal force, this effect is achieved by increasing the spring stiffness or reducing the stroke of the spring that presses the diaphragm of the vacuum amplifier.
The maximum effect of the brake system can only be obtained by completing it in the complex. For better braking, you need to replace the LADA vacuum brake booster, install the LADA rear disc brakes, install larger front brake discs, adjust the brake force distribution and the handbrake.
In this section you can buy the brake pipes for Lada Niva 1600.
Hoses and pipes for brakes
In each brake system there are brake hoses, multi-layer flexible tubes made of especially strong materials. The strength of the hoses is due to the fact that during operation they are subject to high pressure and hydraulic loads.
The brake hose is designed to transfer the impulse to the wheel brake cylinders. When the brake pedal is depressed, the pressure pulse is transmitted via the brake hoses to the wheel cylinders, which in turn compress the brake pads.
In the event of a malfunction of the brake pipes, the braking system as a whole is disrupted, therefore it is necessary to periodically check the brake hoses in order to secure themselves on the road:
- the absence of cracks on the surface;
- reliability in connections;
- the state of the threads on the tubes.
Brake repair kits
In this section you can buy the brake repair kits for Lada Niva 1600.
Repair Kit for brakes
The support is the base that holds and clamps the brake pads. This mechanism, without fail, must be periodically checked for serviceability. A reliable and qualitatively repaired carriage is a pledge of safety and proper braking of the vehicle. If this part has been damaged, it can be repaired. In cases where the possibility of restoration of the support is excluded, a complete replacement of the component is carried out. The support in case of a malfunction can be reanimated on its own, namely, disassemble, clean and replace some parts.
In general, the repair kit of the support consists of the following items:
- clamping springs of shoes;
- the pins of the brake pads;
- cotter pins;
In this section you can buy the brake accessories for Lada Niva 1600.
The brake system of the car is responsible for the safety and life of the driver and passengers, so the owner of the car must carefully monitor the serviceability of the brakes. What matters is the condition of each spare part of the braking system, because a loosened bolt, a jammed piston, or a torn boot can cause an accident.
The basis of the brake system begins with the driver's foot and the convenience of the pedal and ends with a pair of brake pads on each wheel leading to the car stop. Between them is a very complex chain of important things that make up the brake system node.
Our portal has a wide range of such products. We suggest you to buy brake accessories on the LADA Niva 1600.
Order quality accessories from well-known manufacturers right now to unlock the full potential of your car.
Lada NIva Front Brake...
Looking for high quality brake components LADA NIVA? Please, contact us! The catalog of the online store PARTLADA presents a large selection of accessories for all models and years of production of domestic cars of this brand. All sold products are certified, meet the high safety standards and requirements of the manufacturer.
The LADA brakes presented in the assortment are made by well-known domestic companies and belong to the category of premium segment accessories. Thanks to the use of modern technologies by the manufacturers, advanced design and engineering solutions, as well as high-quality materials, the products have exceptional operational properties. At us it is possible to buy any elements of brake system LYADA NIVA - disks and колодки, cables of a lay brake, drums, vacuum amplifiers, repair complete sets, linings and adapters. We also sell certified brake fluids.
Proposed products are different:
- increased resistance to wear;
- resistance to temperature and pressure changes;
- good adhesion with any pads;
- the possibility of rapid braking, regardless of the speed limit.
Due to the presence of perforation on the plane of the discs, there is no gas cushion and a rapid drainage of moisture is ensured. Unique cleaning incisions permanently eliminate contamination from the surface, increasing the efficiency of braking.
Turning to us, you can buy LADA NIVA brakes on the most favorable terms. We carry out direct deliveries from the manufacturer, therefore we form the most loyal prices. We have a flexible system of discounts and special offers, we constantly hold promotions. All spare parts presented in the catalog are available in warehouses, which allows you to quickly organize the delivery to any country.
In this section you can buy the Brakes for Lada Niva 1600.